Welcome to
On Track Automotive
Expert Auto Service and Auto Repair in Burlingame Since 1990
On Track Automotive is your one-stop shop for all auto repair needs in the city of Burlingame, CA. We specialize in automotive repair and maintenance. No matter the type of vehicle you drive, our team has the knowledge to provide you with professional service to ensure your vehicle runs smoothly and safely.
2-Year/24k-Mile NAPA AutoCare Warranty TechNet Warranty Available
Top-notch AUTO
Services
Auto Electrical Services
Maintenance & Auto Service
Engine Auto Service
Exhaust Service
Complete & Reliable
Automotive
Service & Repair
Expert Automotive Services
At On Track Automotive, we use the latest equipment to diagnose and repair your vehicle’s issues efficiently and effectively. We stand behind our work with a guarantee, so you can trust that your vehicle is in good hands.
Auto Repair Estimates in Burlingame
On Track Automotive
What sets On Track Automotive apart from all of the others in Burlingame, CA?
Quality Service
We use the latest diagnostic equipment and high-quality parts to ensure your vehicle is repaired to the highest standards.
Experienced Technicians
Our certified technicians are highly skilled and certified professionals with years of experience in the auto repair industry.
Customer Satisfaction
Our goal is to exceed your expectations and ensure your complete satisfaction with every visit.
Why Choose
On Track Automotive
Maintenance & Auto Service
It’s a fact: regular, quality maintenance extends the life of your vehicle. It also gives you the peace of mind you need.
Exhaust Service
If you’re concerned about passing emissions or you already know your exhaust system isn’t what it should be, visit On Track Automotive in Burlingame.
Auto Electrical
On Track Automotive provides the best electrical auto service in Burlingame, hands down.
Heating & Air Conditioner Repair
For the best cooling and heating auto repair service in Burlingame, trust On Track Automotive.
Engine Auto Service
When that check engine light comes on, it’s hard not to feel annoyed or even worried.
Car service you can trust
Make an Online
Appointment
Recently Serviced Vehicles
-
2021 Hyundai Tucson
Mileage26,678Service Date9/30/2025Services Performed- SET TIRE AIR PRESSURES – 35 psi spare: 60 psi FRONT BRAKES – 60% REAR BRAKES – 65% BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – Needs to be replaced CABIN FILTER – Needs to be replaced LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-50F) TRANSMISSION FLUID CONDITION – OK
- Rotate tires front to rear, torque lug nuts to specification.
- Customer approved to replace engine air filter, clean housing. Customer approved to replace cabin air filter, clean inside of filter housing prior to installing new filter. Secure access plate and glove box assembly.
SUNIL W. gave our service a 5 star review on 9/30/2025 -
2006 Honda CR-V
Mileage81,074Service Date9/19/2025Services Performed- SET TIRE AIR PRESSURES – 30 psi FRONT BRAKES – 10% – 15% REAR BRAKES – 90% BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – Right side brake light bulb is out WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-20F) TRANSMISSION FLUID CONDITION – OK
- Remove and replace headlight bulb. Verified connections are not burnt and verified that the headlight bulb is now functioning properly. Also replace brake light bulb due to bulb being burnt out.
RUSS A. gave our service a 5 star review on 9/21/2025 -
2011 Lexus LX 570
Mileage95,143Service Date9/4/2025Services Performed- Perform plug repair for right rear tire. Re-install tire back onto vehicle and secure spare tire back in storage compartment. Verified TPMS light is staying off at this time.
NANCY T. gave our service a 5 star review on 9/6/2025 -
2006 Toyota RAV4
Mileage129,944Service Date8/22/2025Services Performed- Customer approved to mount and balance all 4 tires including the spare tire. Torque lug nuts to specification.
- Remove and replace all 5 TPMS sensors due to current sensors having no battery life. Fill tire to specification and program all 5 TPMS sensors.
- Customer approved to replace front brake pads, rotors, and calipers. Removed brake caliper along with caliper bracket to allow rotors to be removed. Cleaned hub surface prior to installing new rotors. Install bracket with new brake pads. Install new brake caliper, torque mounting bolts to specification along with brake hose. Replaced brake fluid at the same time. Pump brakes and bleed air out of the system. Drive vehicle to help seat in new brake surfaces.
LONNIE L. gave our service a 5 star review on 8/23/2025 -
2017 Honda Accord
Mileage42,027Service Date7/31/2025Services Performed- Confirmed that the check engine light is on at time of the inspection. Using a hand held electronic scan tool to communicate with the vehicle; Found two faults in the system. 1.P0455: EVAP System (Very) Large Leak Detected 2.P0456: EVAP System Very Small Leak Detected Performed a system check and was able to determine that the purge valve located inside the engine compartment is defective. (will not hold vacuum, stuck in the open position)
- Customer approved to remove and replace defective purge valve. Clear faults and recheck operation , passed. Drove several times to make sure the check engine light stayed off.
MADELINE T. gave our service a 5 star review on 8/1/2025 -
2013 Honda Civic
Mileage101,860Service Date7/18/2025Services Performed- Customer approved to remove and replace the gravel shield assembly along with the hardware. Remove and replace all gravel shield components, secure new gravel shield with new screws and plastic retainers. Verified new gravel shield is secure.
- SET TIRE AIR PRESSURES – 32 psi CONDITION AND AGE OF TIRES – Needs tires due to cracking and age (2820) FRONT BRAKES – 85% REAR BRAKES – 50% – 60% BATTERY – Passed load test (8.2V) CHARGING SYSTEM – OK (13.8V) BELTS – Need to replace belt tensioner due to shock leaking fluid HOSES – Radiator hoses are starting to leak (need to replace both) AIR FILTER – Needs to be changed CABIN FILTER – Needs to be changed LIGHTS – OK WIPERS – OK WINDOW OPERATION – Drivers door window regulator is making noise SHOCKS/STRUTS – Rear shocks need to be replaced due to large leak STEERING COMPONENTS – OK UNDER CARRIAGE CONDITION – Gravel shields need to be replaced COOLANT LEAKS PROTECTION – OK ENGINE OIL FLUID CONDITION – OK (100%) TRANSMISSION FLUID CONDITION – OK DRIVETRAIN FLUID CONDITION – N/A CHECK CONDITION OF MOTOR MOUNTS – OK HOOK UP SCANNER, CHECK FOR FAULTS AND LIVE DATA NUMBERS – (see notes for faults) A/C OPERATION – OK ROAD TEST CONDITION – OK
- Customer approved to remove and replace tensioner assembly. Loosen tension on belt, remove drive belt. Remove and replace tensioner assembly while the gravel shield is removed, torque mounting bolt to specification. Replaced idler pulley at this time due to making noise when spun. Route in drive belt, verify belt is routed properly by cranking engine by hand, tighten new tensioner assembly.
- Customer approved to remove and replace both rear shock absorbers. Remove rear tires and use jacks to support both rear control arms. Remove lower shock mounting bolt. Remove trunk floor cover to gain access to upper mounting bolts, remove upper mounting bolts. Remove and replace both rear shock absorbers, Torque lower mounting bolts to specification then torque upper mounting bolt assemblies to specification. Re-secure trunk floor cover and trim panels. Verified rear shock absorbers are secure and functioning properly when vehicle is lowered.
- Customer approved to remove and replace the upper and lower radiator hoses. Remove coolant drain plug, drain coolant from the system. Remove air intake assembly to gain access to removing upper radiator hose. Remove EGR hose to gain access to thermostat housing. Disconnect upper radiator hose from thermostat housing and radiator assembly. Disconnect lower radiator hose from water pump assembly. Install and secure upper and lower radiator hoses with hose clamps. Re-secure EGR hose along with air intake assembly. Fill cooling system with new coolant, start engine, verify vehicle runs at operating temperature with no leaks present, bleed air out of the system.
- Customer approved to replace engine air filter, clean housing. Customer approved to replace cabin air filter, clean inside of filter housing prior to installing new filter. Secure access plate and glove box assembly.
SCOTT M. gave our service a 5 star review on 7/21/2025 -
2019 Honda Accord
Mileage68,813Service Date7/7/2025Services Performed- SET TIRE AIR PRESSURES – 32 psi spare: 60 psi FRONT BRAKES – 30% REAR BRAKES – 85% BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-34F) TRANSMISSION FLUID CONDITION – OK
PIPER C. gave our service a 5 star review on 7/7/2025 -
2014 Ford Fiesta
Mileage44,480Service Date6/25/2025Services Performed- TIRES – 32psi FRONT BRAKES – 15% – 20% REAR BRAKES – 60% (Drums) BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-34F) TRANSMISSION FLUID CONDITION – OK
JOE D. gave our service a 5 star review on 6/25/2025 -
2007 Toyota Prius
Mileage106,717Service Date6/16/2025Services Performed- Confirmed customer complaint, both headlamps are different intensities. Both headlamp bulbs both different brands which can causing different intensities. Need to replace one bulb so the brands are the same. Tail light bulb needs to be replaced at this time due to being burnt out. Customer approved to remove and replace the right headlamp. Installed Philips bulb to match other Philips bulb already on vehicle. Verified both headlamps are at the same intensity along with the right side tail lamp functioning properly. After headlights have been turned on for awhile and get hot, intensity changes between both lights (left side is dimmer than the right side). Customer needs to return to inspect the left side ballast for a cause.
- Confirmed customer complaint, TPMS light is on at time of inspection. Inspect all 4 TPMS sensors with scanner. Found that 1 sensor is out of battery along with 2 others being low on battery. Recommend replacing all 4 TPMS sensors at this time.
- Customer approved to remove, replace, and program all 4 TPMS sensors. Remove all 4 tires, slightly dismount tire to gain access to TPMS sensor. Remove and replace sensors. Fill tire to specification, torque lug nuts to specification. Use scanner to program all 4 new TPMS sensors. Perform road test, verified TPMS light remains off.
- Customer approved to remove and replace the left side headlamp ballast. Disconnect top of front fascia to gain access to headlamp and module assemblies. Remove the left side headlamp assembly so ballast can be removed. Remove ballast cover, remove ballast (module) from housing. Upon further inspection, found that cable and socket going from ballast cover to ballast is corroded, need to replace cover and cable at this time. Secure new ballast to headlamp assembly. Installed new bulb at the same time (both bulbs are now new). Secure ballast cable along with cover and cable to headlamp assembly. Re-install headlamp assembly, secure mounting bolts and cables. Re-secure front fascia. Turn on headlights and verify both headlamps remain at same intensity over time.
DAN V. gave our service a 5 star review on 6/18/2025 -
2007 Toyota Prius
Mileage146,740Service Date5/30/2025Services Performed- SET TIRE AIR PRESSURES – Front: 35 psi Rear: 33 psi FRONT BRAKES – 80% REAR BRAKES – 40% (Drums) BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-50F) TRANSMISSION FLUID CONDITION – OK
- Customer approved to remove and replace leaking water pump along with replacing the drive belt. Release belt tensioner so belt can be removed along with the idler pulley. Inspect idler pulley for noise to replace if needed. Disconnect cooling hoses from water pump and drain coolant from the system. Remove and replace water pump assembly with new gasket, clean surrounding area of coolant residue during this process. Secure mounting bolts and cooling hoses to new water pump. Secure new drive belt, verify new drive belt is routed properly, secure belt by tightening belt tensioner. Fill vehicle with new coolant, bleed air out of the system. Start engine, verified vehicle runs smoothly at operating temperature with no leaks present.
THOMAS A. gave our service a 5 star review on 5/31/2025 -
2005 Lexus LS 430
Mileage97,441Service Date5/28/2025Services Performed- Customer approved to mount and balance 2 new tires. Mount and balance both rear tires, rotate new rear tires to front. Torque lug nuts to specification. Secure spare tire back into storage compartment.
PETER K. gave our service a 5 star review on 6/5/2025 -
2010 Honda Accord
Mileage181,402Service Date5/8/2025Services Performed- SET TIRE AIR PRESSURES – 32 psi FRONT BRAKES – 40% REAR BRAKES – 30% BATTERY – Passed load test (10V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-50F) TRANSMISSION FLUID CONDITION – OK
PAM B. gave our service a 5 star review on 5/12/2025
Contact Us Today for an Auto Repair Estimate
Hours
Mon-Fri : 8am-6pmSat-Sun : Closed
