Name: On Track Automotive
Address: 1101 California Dr, Burlingame, CA, 94010-3505
Telephone: (650) 343-4594

2011 Honda CR-V
Mileage
132,720
Service Date
12/2/2025
Services Performed
Confirmed customer complaint, no warm air is being blown. Inspect operation of the blend door actuators. Found that the driver side temperature blend door is not moving when it is activated. Use wire diagram to properly measure input and output voltages, all voltages are normal readings. Used terminal cleaner to clean the connector side and actuator side terminals. Re-secure actuator to connector and perform re-calibration. Actuator is functioning properly at this time, warm air is being blown out of vents when climate control is adjusted.
DON W. gave our service a 5 star review on 12/4/2025
2010 Honda Accord
Mileage
184,532
Service Date
11/18/2025
Services Performed
SET TIRE AIR PRESSURES – 32 psi spare: 60 psi FRONT BRAKES – 40% REAR BRAKES – 25% BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – Need to replace SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-50F) TRANSMISSION FLUID CONDITION – OK
Customer approved to remove and replace the oil filter housing O-rings due to leaks. Remove exhaust bracket so housing can be removed. Remove oil filter housing and clean the O -ring area of oil residue. Install new O-ring gaskets for oil filter housing. Re-secure oil filter housing and torque bolts to specification. Re-install exhaust bracket that was previously removed. Let vehicle run and re-check for leaks at oil filter housing, none found at this time.
Customer approved to clean the oil filter housing and axle shaft area of oil residue. Replaced oil filter housing gaskets. Customer needs to return to verify axle shaft seal leak along with possible seal replacement at that time.
Customer approved to remove and replace both front wiper blades. Verified blades fit and operate properly.
PAM B. gave our service a 5 star review on 11/21/2025
2006 Honda CR-V
Mileage
81,074
Service Date
9/19/2025
Services Performed
SET TIRE AIR PRESSURES – 30 psi FRONT BRAKES – 10% – 15% REAR BRAKES – 90% BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – Right side brake light bulb is out WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-20F) TRANSMISSION FLUID CONDITION – OK
Remove and replace headlight bulb. Verified connections are not burnt and verified that the headlight bulb is now functioning properly. Also replace brake light bulb due to bulb being burnt out.
RUSS A. gave our service a 5 star review on 9/21/2025
2017 Honda Accord
Mileage
42,027
Service Date
7/31/2025
Services Performed
Confirmed that the check engine light is on at time of the inspection. Using a hand held electronic scan tool to communicate with the vehicle; Found two faults in the system. 1.P0455: EVAP System (Very) Large Leak Detected 2.P0456: EVAP System Very Small Leak Detected Performed a system check and was able to determine that the purge valve located inside the engine compartment is defective. (will not hold vacuum, stuck in the open position)
Customer approved to remove and replace defective purge valve. Clear faults and recheck operation , passed. Drove several times to make sure the check engine light stayed off.
MADELINE T. gave our service a 5 star review on 8/1/2025
2013 Honda Civic
Mileage
101,860
Service Date
7/18/2025
Services Performed
Customer approved to remove and replace the gravel shield assembly along with the hardware. Remove and replace all gravel shield components, secure new gravel shield with new screws and plastic retainers. Verified new gravel shield is secure.
SET TIRE AIR PRESSURES – 32 psi CONDITION AND AGE OF TIRES – Needs tires due to cracking and age (2820) FRONT BRAKES – 85% REAR BRAKES – 50% – 60% BATTERY – Passed load test (8.2V) CHARGING SYSTEM – OK (13.8V) BELTS – Need to replace belt tensioner due to shock leaking fluid HOSES – Radiator hoses are starting to leak (need to replace both) AIR FILTER – Needs to be changed CABIN FILTER – Needs to be changed LIGHTS – OK WIPERS – OK WINDOW OPERATION – Drivers door window regulator is making noise SHOCKS/STRUTS – Rear shocks need to be replaced due to large leak STEERING COMPONENTS – OK UNDER CARRIAGE CONDITION – Gravel shields need to be replaced COOLANT LEAKS PROTECTION – OK ENGINE OIL FLUID CONDITION – OK (100%) TRANSMISSION FLUID CONDITION – OK DRIVETRAIN FLUID CONDITION – N/A CHECK CONDITION OF MOTOR MOUNTS – OK HOOK UP SCANNER, CHECK FOR FAULTS AND LIVE DATA NUMBERS – (see notes for faults) A/C OPERATION – OK ROAD TEST CONDITION – OK
Customer approved to remove and replace tensioner assembly. Loosen tension on belt, remove drive belt. Remove and replace tensioner assembly while the gravel shield is removed, torque mounting bolt to specification. Replaced idler pulley at this time due to making noise when spun. Route in drive belt, verify belt is routed properly by cranking engine by hand, tighten new tensioner assembly.
Customer approved to remove and replace both rear shock absorbers. Remove rear tires and use jacks to support both rear control arms. Remove lower shock mounting bolt. Remove trunk floor cover to gain access to upper mounting bolts, remove upper mounting bolts. Remove and replace both rear shock absorbers, Torque lower mounting bolts to specification then torque upper mounting bolt assemblies to specification. Re-secure trunk floor cover and trim panels. Verified rear shock absorbers are secure and functioning properly when vehicle is lowered.
Customer approved to remove and replace the upper and lower radiator hoses. Remove coolant drain plug, drain coolant from the system. Remove air intake assembly to gain access to removing upper radiator hose. Remove EGR hose to gain access to thermostat housing. Disconnect upper radiator hose from thermostat housing and radiator assembly. Disconnect lower radiator hose from water pump assembly. Install and secure upper and lower radiator hoses with hose clamps. Re-secure EGR hose along with air intake assembly. Fill cooling system with new coolant, start engine, verify vehicle runs at operating temperature with no leaks present, bleed air out of the system.
Customer approved to replace engine air filter, clean housing. Customer approved to replace cabin air filter, clean inside of filter housing prior to installing new filter. Secure access plate and glove box assembly.
SCOTT M. gave our service a 5 star review on 7/21/2025
2019 Honda Accord
Mileage
68,813
Service Date
7/7/2025
Services Performed
SET TIRE AIR PRESSURES – 32 psi spare: 60 psi FRONT BRAKES – 30% REAR BRAKES – 85% BATTERY – Passed load test (9V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-34F) TRANSMISSION FLUID CONDITION – OK
PIPER C. gave our service a 5 star review on 7/7/2025
2010 Honda Accord
Mileage
181,402
Service Date
5/8/2025
Services Performed
SET TIRE AIR PRESSURES – 32 psi FRONT BRAKES – 40% REAR BRAKES – 30% BATTERY – Passed load test (10V) BELTS – OK HOSES – OK AIR FILTER – OK CABIN FILTER – OK LIGHTS – OK WIPERS – OK SHOCKS/STRUTS – OK COOLANT PROTECTION – OK (-50F) TRANSMISSION FLUID CONDITION – OK
PAM B. gave our service a 5 star review on 5/12/2025
We Service and Repair All Honda Cars
Services Performed

All General Repair and Maintenance

Honda